Paying and Submitting Runs

Overview

After checking your geometry in the 3D Viewer and checking your Simulation settings, you are now ready to Submit.

How to Pay for Runs

Tokens will be used as payment for TotalSim Web. Each token will have a retail value of $20.

Disclaimer: We reserve the right to adjust without notice the retail value of each tokens and also the tokens needed to run for each App.

Please email us if your company requires a Quote.

Purchasing Tokens

  • Click on New Run
  • Under Pricing, click on Account Page
  • Click on Manage Cards to add/remove Credit Cards
  • Click Confirm after adding Credit Card Information
  • Enter Quantity and click on Checkout

Price

The cost per run is 20 tokens.

Multiple runs with the same geometry configuration will be discounted. The base cost for runs with unique-geometry is 20 tokens and additional runs with the same geometry configuration would cost 7 tokens. You would be able to receive this discount by selecting the same geometry in the Run Setup or by running a Parametric Sweep.

Transient simulations are also available and need to be started from a completed steady state run. As transient simulations are computationally expensive, TotalSim will manually start the simulation to make sure it starts properly. Please email app-support@totalsim.us if you wish to run a transient simulation. The cost for a transient simulation is 80 tokens.

Submitting Run

  • A Quote for the run will be given to you at the top of the page under Pricing. Check to see if you has enough tokens for the run.
  • If there are errors, then a list of errors will printed in red below the Save, Submit, Delete, Show 3d view, and Duplicate buttons. These errors will need to be addressed before the run can be submitted.
  • If there are no errors, click on blue Submit button.
  • You have the ability to kill the job after submitting, but prior to run publishing. However, you will still be charged for the full run. To kill job, click on Delete.

Duplicating Run

If you want to make one small change or want to run the same simulation with different geometry, you can duplicate the run without having to re-setup the simulation.

  • Click on the Run you want to duplicate
  • At bottom, click Duplicate
  • It will automatically rename the run as parentRun.1, butyou are able to change the name of the new Run.
  • Make your intended changes
  • Click Save and check 3D Viewer
  • Click on Submit

Duplicating Run after Run Completion

You also have the ability to duplicate a run after a run has completed.

  • Click on Run that you want to duplicate
  • Click on Details at the results navigation bar. This will show a summary of your Run Setup.
  • At the bottom, click Duplicate
  • Make your intended changes
  • Click Save and check the 3D Viewer
  • Click on Submit